Solution. Press the film rewind button found on the bottom of the camera. Once the film rewind button has been pressed you finger may be removed from it. Raise the film rewind crank, turn it clockwise as indicated in the photo by the arrow and rewind the film into the cartridge. When the film rewind button stops revolving and rewinding Removing the scratches requires removing material (some of the Al or some of the paint If it's painted) from the frame. Realistically it'd be best to try to polish lightly by hand to reduce the appearance of the scratches. Hold the bulb a few inches from the sensor and liberally squeeze away. If stubborn dust specs prove unmoved by the air bulb, you can follow up with a swab-based cleaning tool and specially made Nov 8, 2014. #5. colyn1353 said: What you are seeing is the lens itself which is protected by the outer glass which should be solid without a hole. You can lightly press on the plastic covered glass. It someone has drilled a hole then the plastic would slightly be pressed into any hole. To pick up on the example from above, say you found an old Nikkormat with a 50mm f/1.4 lens on it. This lens has an automatic diaphragm that closes down when the camera is fired. By first removing the lens from the camera and then turning the aperture ring, you should be able to physically observe the aperture moving inside the lens. First, press the film release button on the bottom of the camera. It should be a tiny button just below where the film canister is inside the camera. Directly above this, on the top of the camera, is your rewind crank. Fold the crank out and turn it in the direction of the arrow. xBYEQZ. Anything in the canister should not be a problem to develop. I have done this before, and the only way to remove snapped film without exposing it is in a darkroom or changing bag. Also, just in case it was the issue, there may be a button on the bottom of the camera. Thats the release that lets you wind the film back in the camera. In this video I show you how to load 35mm film into the Canon FTb. I also demonstrate how to rewind the film after the roll has been finished and remove the Clean the film holders: If the film holders have accumulated dust or debris, clean them using a soft brush or a can of compressed air. Ensure that no particles are present that could interfere with the film during scanning. Check and clean the film path: Some scanners have a film path or transport mechanism. This is how you remove film from a disposable camera (Kodak FunSaver). Some film labs charge up to $2 to do this for you, we're here to show you how you can A short instruction video for beginners on how to put a roll of film into an Olympus Trip 35 camera. I also show you how to remove the film before developing.

how to remove film from camera